Free CCNA Routing & Switching Exam Practice Test

With the free CCNA practice test, you can methodically prepare for your CCNA certification exam with ease. Take the CCNA exam questions and identify which areas of the Cisco switching and routing concepts you are well-versed in and which areas need work. This CCNA test is for those who prefer to map their progress. This CCNA 200 practice exam can be taken multiple times and is free of cost. If you are someone who prefers to take an exam well-prepared, then these CCNA practice exam is for you! Give it a shot today!

  • 60 Questions,
  • 90 Minutes
Instructions:

1. This is a FREE test and can be attempted multiple times. But it is recommended to take the test when you are ready for best practice experience.

2. Test Duration: 90 Minutes

3. Number of questions: 60 Multiple Choice Questions

4. Each question has multiple options out of which one or more may be correct

5. You can pause the test in between and you are allowed to re-take the test later. Your test will resume from where you left, but the test time will be reduced by the amount of time you've taken in the previous attempt.

Please fill the form below to start the Practice Test
Name*
Email*
+91-
Phone Number*
{{seconds | secondsToDate | date:'HH:mm:ss'}} Time remaining
1. Which of the following protocol negotiates the formation of an EtherChannel?
2. Which of the following is NOT an option to establish an EtherChannel?
3. Which of the following is NOT a port role in Common Spanning Tree Protocol?
4. Which of the following can lead to network failure?
5. The ------- is the interface on a switch with the lowest root path cost.
6. Which of the following is NOT a valid configurations for the ip default-network command?
7. Which of the following MAC address type becomes part of the running configuration?
8. Which of the following is NOT one of the 3 Ps of applying ACLs?
9. Switch latency includes the time spent in all but which of the following activities?
10. Outbound ACLs process packets --------.
11. ACEs in an access list should be entered in order of ------------.
12. Standard access lists should be applied as close to the ----------- as possible.
13. An inside local address is -------.
14. Use the image given to answer the following question. Which negotiation protocol, if any, was used to create the trunk?
15. Use the image given to answer the following question. Which STP could not have been configured on this switch?
16. Use the image given to answer the following question. How many VLANs are on switch S2?
17. Use the image given to answer the following question. Which VLAN ID is the native VLAN?
18. If only IPv6 routing is used, which of the following commands is required for OSPFv3?
19. A(n) ----------- must be configured before Telnet or SSH is used to reach the device.
20. Which type of cable is used to connect two PCs?
21. Which Cisco device would probably have more FastEthernet interfaces?
22. By default, the OSPF dead interval is set to ---------- times the hello interval.
23. In Frame Relay, the Frame Relay switch is the ---------- device.
24. Use the image given to answer the following question. PC A initiates a file transfer with PC B. The Layer 2 destination address used to send this information to PC B is --------.
25. Use the image given to answer the following question. PC D sends an email to PC B. The Layer 2 destination address used to send this information to PC B is ---------.
26. Use the image given to answer the following question. PC A sends an email to PC B. The Layer 3 destination address used to send this information to PC B is --------.
27. Use the image given to answer the following question. S2 receives Layer 2 frames with a MAC destination address of an S2 interface. What type of datagram meets this criteria?
28. Which OSI layer is responsible for user interaction?
29. A(n) ----------- is responsible for packet forwarding.
30. All the routers in an OSPF area have identical LSDBs in the ------ link state.
31. One of the Layer 2 Ethernet sublayers are --------.
32. An example of an adjacent-layer interaction is -------.
33. The address 2.1.45.255/8 is a ------------- address.
34. Use the image given to answer the following question. This is an example of a-------.
35. Use the image given to answer the following question. The mnemonic portion of the message is ----------.
36. Use the image given to answer the following question. This message is generated when the ------------ command is issued.
37. IPv4 addresses are split into -------- main classes.
38. An example of a classful network is ---------.
39. The number of usable host addresses on a subnet with mask 255.255.255.240 is ----.
40. The show ip flow export command is used to verify ----- .
41. When a PC needs to send a packet to a destination outside of its own subnet, it sends the packet to the -------.
42. The decimal number 27 is expressed in hexadecimal as --------- .
43. To enter privileged exec mode, enter the ________ command.
44. To show the configuration that has been saved, enter the -------command.
45. The command ip route 10.1.1.0 255.255.255.0 fa0/0 is an example of --------.
46. Issue the --------- command to check ---------- before issuing a debug command.
47. The IP address 64.0.0.1 can be expressed in hexadecimal as ---------.
48. In a SOHO environment, the -------- device acts as a DHCP server and client.
49. The medium used for wireless communications is ---------.
50. Which of the following is not IGP?
51. Which of the following is a category of IGP?
52. An EGP routes ------------ autonomous systems.
53. Which of the following is not a type of LMI?
54. Which of the following is not a routing source?
55. Which is the next router encountered when the packet leaves the egress interface?
56. On which of the following was the DLCI defined?
57. Use the image given to answer the following question. What is the Layer 2 address of this interface?
58. Use the image given to answer the following question. Which parameter ensures that this DLCI can pass routing protocol information?
59. Use the image given to answer the following question. Binary 11000001 is expressed in hexadecimal form as -----.
60. In a SOHO environment, -----subnet(s) are normally used.
{{ seconds | secondsToDate | date:'HH:mm:ss'}} Time remaining
NOTE

All test progress will be lost in case you close the browser without finishing the test. Please finish the test to access your results.

Frequently Asked Questions

  • What is the CCNA practice test?

    The CCNA practice test is free of cost is a simulation of the actual CCNA routing and switching exam. This practice test consists of 60 MCQs that are based on the CCNA exam questions, which must be answered in a duration of 90 minutes. The main aim of this practice test is to help candidates in identifying concepts they are well-versed in and the areas they need to work on.

  • Will the CCNA practice test be updated frequently?

    Yes. We update the mock tests on a regular basis so candidates are provided with the latest information at all times.

  • Will the CCNA sample questions help in clearing the actual certification exam?

    Yes. The CCNA sample questions are indicative of what you will be facing in the exam conducted by Cisco. This mock test doesn’t guarantee that you will clear the exam but it makes clearing the CCNA certification exam a lot easier.

  • What is included in this CCNA practice exam?

    This CCNA practice exam consists of 60 MCQs, which need to be answered in a duration of 90 minutes and can be retaken several times. Also, the test can be paused at any time and resumed later.

  • Can I retake this Practice Test?

    Yes. Candidates are allowed to retake the CCNA practice test as many times as they want. However, attempting the test after the candidates have prepared well will give them the best practice experience.

  • Who can take up this CCNA practice exam?

    The CCNA practice questions are particularly beneficial for IT technicians and entry-level engineers. Additionally, professionals who want to take on the roles of systems engineers, network support specialists, network specialists, network consultants, and network administrators will also benefit from the CCNA practice test.

  • Are these the same questions I'll see on the actual CCNA exam?

    The CCNA practice questions are similar to the actual CCNA routing and switching exam questions.

  • What will I learn from this practice test?

    There are over 60 multiple choice questions present in this CCNA practice test. These questions are designed to test candidates in Cisco switching and routing concepts. The CCNA practice test helps candidates in the methodical preparation of the CCNA certification exam and is an ideal tool to map their progress.

  • I didn’t do well on this practice test. What should I do now?

    The CCNA practice test can be taken up any number of times. If the candidates fail to clear the test in their first attempt, they can prepare from the CCNA-Routing & Switching course and retake the test after preparing for the CCNA concepts.

  • What are the requirements to take this practice test?

    This CCNA online practice test does not have any requirements and can be taken up by professionals who seek experience in the telecommunications and networking domain.

  • Disclaimer
  • PMP, PMI, PMBOK, CAPM, PgMP, PfMP, ACP, PBA, RMP, SP, and OPM3 are registered marks of the Project Management Institute, Inc.

Request more information

For individuals
For business
Name*
Email*
Phone Number*
Your Message (Optional)
We are looking into your query.
Our consultants will get in touch with you soon.

A Simplilearn representative will get back to you in one business day.

First Name*
Last Name*
Email*
Phone Number*
Company*
Job Title*